To serve you better, we've assembled a list of our customers' most frequently asked questions. If you don't find your answer here, feel free to contact us.

You could possibly have a leaky toilet or faucet that's difficult to detect.  A quick check of your meter will indicate a possible leak.  Make sure that all of your faucets are turned off, no showers, appliances, etc. are running.  Go out and look at your meter.  If the meter is turning, even just a little, that would be an indication of a leak.

If you are still not satified, we can also go out and pull a log since we've upgraded all of our meters to remote read.  Just be cautioned that the cost of a log pull is $75.00.  If you require further assistance, call the office and we'll work with you to solve the problem.

Check your meter and the surrounding area for possible leaks. Next, call our office and report low pressure for your area.

A repair could have been completed recently allowing air to enter the line, causing the milky look.

Only chemicals that are approved by the National Safety Foundation for treatment of drinking water.

All public water systems are required to maintain a minimum chlorine level of 0.2 mg/L (tested at the end of each line) by state law. Systems that use chloramine as a disinfectant must maintain a level of 0.5 mg/L by state law. Our disinfectant levels are tested daily to ensure safety.

Most likely your water heater needs to be flushed. CAUTION: Most manufacturers recommend hiring a professional to flush your water heater. If you plan on doing this yourself, read the owner's manual to keep from being hurt and or damaging the water heater.

We may have received it after the due date or we may not have received it at all. Call our office and we will help you solve the problem.